|
Configuration Description
The call-router ‘limiter’ service limit offers with a flexible technique to limit the maximum number of concurrent calls. It also limits the call-setup rate within a system. Calls exceeding the defined limits can either be simply dropped or they can be handled differently. A call is counted as an active call as soon as the call-setup message reaches the limiter service. The call remains active until the signaling has completed tearing down the call.
Commande Sequence to copy, edit and paste
#-----------------------------------------------------------------#
# #
# SMARTWARE 5.X #
# #
# Service Limiter config example #
# #
# Similarly the call-setup-rate could be limited by using the #
# ‘exceed max-call-rate’ instead of the ‘exceed maxcalls’ command #
# in the limiter-port configuration mode. There is no limitation #
# on the number of ports a limiter can have. You can create as #
# many as you need for your application. #
# #
# DATE: 2011-01-05 #
# AUTHOR: Thomas Tlapak #
# PATTON-INALP-NETWORKS; CH-3172 NIEDERWANGEN #
# WWW.PATTON.COM WWW.INALP.COM #
# #
# #
#-----------------------------------------------------------------#
context cs switch
interface isdn VOICEMAIL
interface isdn LOCALEXCHANGE
route call dest-service mylimiter.inbound
interface sip IF_SIP
bind context sip-gateway GW_SIP
route call dest-service mylimiter.outbound
# Enter below the IP of the softswitch / sip server
remote <0.0.0.0>
service limiter mylimiter
max-calls 20
port inbound
route call dest-interface IF_SIP
exceed max-calls route call dest-interface VOICEMAIL
port outbound
route call dest-interface LOCALEXCHANGE
context cs switch
no shutdown
| 
(8748 vote(s))
Helpful
Not helpful