How do I have to configure the SmartNode to work as Lync PSTN and Terminal Gateway
Posted by , Last modified by Daniel Lizaola on 14 December 2017 04:59 PM

To enhance Lync with a legacy PSTN or an analogue terminal a Voice over IP gateway is required. The SmartNode products line, Certified for Lync by Microsoft, is the right choose for such a scenario.

A step by step configuration guide to configure the SmartNode to work with Lync can be found in the attached presentation. Please find also the required and within the presentation mentioned configuration file within the attachment.

Please note that ActiveX must be enabled to have a full featured presentation.

In case the attachment mentioned above are missing, please follow the following link:

Lync article attachments


Attachments 
 
 smartnodeucsseminar_lync.ppsm (4.99 MB)
 4xxx_fxs_to_lync.txt (2.78 KB)
 4638_isdn_te_to_lync.txt (5.24 KB)
(8748 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).