SEARCH
Knowledgebase: Unified Communications > SmartNode > SmartWare
Auto Provisioning with Timers and System MAC
Posted by , Last modified by Daniel Lizaola on 14 December 2017 05:26 PM

Configuration Description

This configuration checks 2 minutes after boot up for new firmware and if available downloads and istalls it. Furthermore the server will be checked every minute for new firmware.

Furthermore SmartNode checks 30 minutes after bootup and then every minute for a new configuration on the specified server. Should a newer configuration be available it will be download, installed and the SmartNode rebooted to activate the new configuration.

Note: Reload takes only effect as long as there is no phone call ongoing.
# Replace all <>-variables with appropriate IP-address or dns-name

Command Sequence to copy, edit and paste in the following link


configuration example



Attachments 
 
 autoprovisioning.cfg (0.47 KB)
(8748 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).