Configuration Description
Port and context ip configuration for a ADSL PPPoEoA (point to point over Ethernet over ATM) link over a SmartNode VoIP-Gateway.
This example is for SmartNode models using the ADSL interface which is indicated by "/A" in the product SKU.
In case a PPPoA (point to point over ATM, without Ethernet layer) is required, please see the corresponding article. Link to PPPoA article.
Commande Sequece to copy, edit and paste
#----------------------------------------------------------------# # # # SN465X / SN485X / SN467X ADSL-VOIP-GATEWAY # # # # Sample-Configuration, including the IP-Router # # # # Please replace all variables before you are using this # # configuration. # # # # Author: MA, Patton-Inalp Netowrks, CH-3172 Niederwangen # # Date: 2014-06-27 # # # #----------------------------------------------------------------#
profile napt NAPT_WAN
profile ppp default
context ip router
interface IF_WAN ipaddress <set your ip-addres and ip-mask or use unnumbered> mtu 1492 point-point use profile napt NAPT_WAN tcp adjust-mss rx mtu tcp adjust-mss tx mtu
context ip router route 0.0.0.0 0.0.0.0 IF_WAN 0
subscriber ppp SUB_ADSL_1 dial out authentication chap identification outbound <ADSL-Username> password <ADSL-Password> bind interface IF_WAN router
port dsl 0 0
annex <set the annex to be used; [a|b|m]>
pvc-ethernet vpi <set your vpi number> vci <set your vci number>
pppoe
session SES_ADSL bind subscriber SUB_ADSL_1 no shutdown
|