The model 3201 and model 3241 DiamondLink routers offer high-speed
standards-based for long reach network extension. The model 3201
provides rates up to 2.3 Mbps and the model 3241 offers rates up to
4.6 Mbps. Connect them back-to-back or use them with on...
Procedure:
1. Reboot router while holding the spacebar; make sure you are
connected using the console port. (this will start unit in Boot OS)
2. Once you see the "]" prompt and see the cursor moving across the
screen you can stop holding down the spac...
G.SHDSL is the newest standard for symmetric DSL. It works over
2-wires and improves both the distances achievable by DSL and the
spectral compatibility with other services often present in a twisted
pair bundle. The ITU standard for G.SHDSL is G.911....
In order to establish a G.HSDSL connection, there must be a modem on
each end of the link. This does not mean that a DiamondLink/IAD modem
must be on each end. The DiamondLink/IAD modem can be used with the
following options on the other end of the twist...
Yes, both of these models support NAT (RFC3022) with Network Address
Port Translation(NAPT). They also support MultiNat with 1:1, Many:1,
Many:many mapping as well as Port/IP redirection and mapping.
Yes. They automatically learn, age and filter 1,024 source addresses.
Destination addresses of incoming frames are compared with the Source
Address in the address table and discarded if an entry exists;
otherwise, they are forwarded over the DSL Extensio...
They are capable of connecting to Ethernet Hubs and Switches,
remote PCs and any other network enabled device. The MDI-X switch is
used to allow the units to connect to either a hub(DCE) or PC(DTE)
device eliminating the neede to decide whether a stra...
Some typical applications are:
1. Enterprise/Campus users deploying point-to-point network
extensions 2. PTTs who want to offer standards-based DSL service using
3201 or 3241 as CPE to DSLAMs. 3. ILECs/CLECs connecting service to
secondary metropolitan ...
The DiamondLink G.HSDSL routers supports all the SHDSL standards
developed by ANSI (T1E1.4/2001-174, ETSI(TS 101524) and
ITU-T(G.991.2). The routers offer selectable support for both Annex A
(North America) and Annex B(Europe). They implement TC-PAM 16 a...
Yes, the DiamondLink routers are protected in compliance with all FCC
Part 68 and UL1950 specifications. In addition, the DiamondLink
routers are designed to meet ITU-T recommendation K12.
These models can easily be configured using several methods. The are
user selectable to allow ATN, PPP or HDLC WAN data link connections
and allow a variety of local and remote configuration and management
options:
1. Web-based configuration via embed...
* Point-toPoint Protocol over HDLC
* PPPoA(RFC2364) Point-to-Point Protocol over ATM
* PPPoE(RFC 2516) Client for autonomous network connection.
Eliminates the requirement of installing client software on a local PC
and allows sharing of the conne...
