Why does a command entered into the CLI does not appear in the 'show running-config'.

Knowledgebase

(428)Unified Communications (65)Network Access (27)Connectivity (4)Provisioning (5)Patton Cloud

Why does a command entered into the CLI does not appear in the 'show running-config'. Posted by Elena Brambilla, Last modified by Daniel Lizaola on 12 December 2017 05:23 PM
If the command entered happens to be a default value (e.g. sntp-client poll-interval 60) the command is not displayed in the running-config but nevertheless active. This means that only commands and values other than defaults are displayed in the running-config.
(8764 vote(s)) Helpful Not helpful

Comments (0)

Post a new comment Reply to comment
Post a new comment Reply to comment

CAPTCHA Verification
CAPTCHA Verification

Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).