Knowledgebase: Unified Communications > SmartNode
|
How to change the Payload type when using Transparent Clearmode with Cisco Equipment?
Posted by Elena Brambilla, Last modified by Daniel Lizaola on 12 December 2017 04:54 PM
|
|
|
Unfortunately at this time there is no way to change the RTP Payload type when using the named ‘transparent-cisco’ codec. Because Cisco deviates from the excepted standard protocol the Smartnode has a second Codec for communication specifically with Cisco Equipment. The command ‘rtp payloadtype transparent-clearmode’ will only effect the codec named ‘transparent-clearmode’. Because of this limitation please be aware that ‘transparent-cisco’ will always communicate with a payload type of #116 so you must change the remote equipment accordingly. | |
 (8761 vote(s)) Helpful Not helpful |
Comments (0)