Adding a default gateway to the CopperLink 2160 management port.
Posted by Danny Staub, Last modified by Danny Staub on 15 November 2017 03:32 PM

1)      Console or Telnet into the unit and login.

2)      Click on "enable" and enter Supervisor password with is "root" by default.

3)      Go to "setup".

4)      Go to “bridge”

5)      Enter the Gateway address here

6)      Go back to the main screen and go to “write”

7)      Save the config and reboot the unit.

The unit will now have a default gateway specified for the 2160.

(8748 vote(s))
Not helpful

Comments (0)
Post a new comment
Full Name:
CAPTCHA Verification 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).