SEARCH
Knowledgebase: Unified Communications > SmartNode > SmartMedia > SN10K
Basic Steps to setup a SmartMedia configuration (SIP and ISDN)
Posted by Laszlo Varro, Last modified by Daniel Lizaola on 19 December 2017 01:54 PM

This article guides you trough a step by step task list, to get a SmartNode SN10k configured.

At the end your SmartNode SN10k will be ready to handle calls from SIP to ISDN and versa.

 

Step 1) Hardware

Adding New Hardware In SmartMedia

Create the TDM network on SmartMedia

Configuring VoIP Interfaces

 

Step 2) Protocol Stacks

Configuring ISDN on SmartMedia

Configuring SIP on SmartMedia

 

Step 3) Routes

Creating a Static Route

 

Step 4) Troubleshooting

Configuring Call Trace

(8748 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).