Adding New Hardware In SmartMedia
Posted by Laszlo Varro, Last modified by Dan Smith on 25 July 2018 03:00 PM
|
|
When you receive a new system, at least one hardware configuration will have been set in the Toolpack application server, by default. To add other hardware devices, you must use the SmartMedia Web Portal To add one or more additional hardware devices to the Toolpack system configuration, their serial numbers must be registered with the Toolpack application server.
1- Click Hardware in the navigation panel
NOTE The following image shows the 1+1 Backup field set. This is done for the addition a secondary TMP that will operate as the designated 1+1 backup in a 1+1 Group. 4- Verify that the "Adapter was successfully created" message appears, and that the newly added hardware device appears in the Hardware List below | |
|