SEARCH
Knowledgebase: Unified Communications > SmartNode > SmartMedia > SN10K
Creating SAP( Service Access Point ) on SmartMedia
Posted by Zsolt Erdei, Last modified by Dan Smith on 25 July 2018 03:10 PM

Now that you have created a SIP stack and a transport server, you must must create a new service access point (SAP) for your configuration. The Service Access Point is used to bind the SIP stack with a transport server. Depending on the system configuration, multiple SAPs can be configured.

To create a new SIP SAP:


1- Click SIP in the navigation panel

Toolpack v2.5 Navigation Panel SIP.png


2- Click Edit next to the SIP stack for which you wish to create a SAP

Toolpack v2.5 Edit SIP.png


3- Click Create New Sap under the Service Access Points menu

Toolpack v2.5 Create SAP.png


4- Create the new service access point:

  • Enter a name for the SAP
  • Click Create

Toolpack v2.5 Creating SAP.png


5- Verify that the "SipSap was successfully created" message appears

Toolpack v2.5 SAP Created.png


6- Associate the previously created SIP transport server with your new configuration:

  • Select a transport server from the list of available servers
  • Associate this configuration by clicking the "<<" button
  • The transport server will now appear in the list to the left

Toolpack v2.5 Associate Server.png

(8748 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).