SEARCH
Knowledgebase: Unified Communications > SmartNode > SmartMedia > SN10K
Creating SIP Stack on SmartMedia
Posted by Zsolt Erdei, Last modified by Dan Smith on 25 July 2018 03:08 PM

Session Initiation Protocol, more commonly known as SIP, is a signaling protocol for packet-based networks and is commonly used, along with H.323 to provide signaling for voice over IP (VoIP) communications. You must now configure SIP signaling for your system. The first step in doing so is to create a SIP stack. To do so:


1- Click SIP in the navigation panel

Toolpack v2.5 Navigation Panel SIP.png


2- Click Create New Sip

Toolpack v2.5 Create SIP.png


3- Create the new SIP stack:

  • Verify that the box labeled Enabled is checked
  • Enter a name for the stack
  • Select a virtual adapter
  • Click Create

Toolpack v2.5 Creating SIP.png


4- Verify that the "SipCfg was successfully created" message appears

Toolpack v2.5 SIP Created.png

(8748 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).