SEARCH
Knowledgebase: Unified Communications > SmartNode > SmartMedia > SN10K
Creating PortRange on SmartMedia
Posted by Zsolt Erdei, Last modified by Dan Smith on 25 July 2018 03:08 PM

Now that you have properly allocated all of your system's physical interfaces, you must create a new RTP port range.

To create an RTP port range:

1- Click IP Interfaces in the navigation panel

Toolpack v2.5 Navigation Panel IP Interfaces.png


2- In the IP Interfaces window, click Create New Port Range

Toolpack v2.5 Create Port Range.png


3- Create the new RTP port range:

  • Enter a name for the port range
  • Select an IP interface
  • Enter a port min value
  • Enter a port max value
  • Click Create

Toolpack v2.5 Creating Port Range.png


4- Verify that the "PortRange was successfully created" message appears

Toolpack v2.5 Port Range Created.png

(8748 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).