SEARCH
Knowledgebase: Unified Communications > SmartNode > SmartMedia > SN10K
Why is my SN10K getting an "IE: Cause NoCircuitChannelAvailable" message when placing a call from ISDN to SIP?
Posted by Danny Staub, Last modified by Danny Staub on 15 November 2017 02:48 PM

Under Signaling/ISDN, click to edit the ISDN stack that was created.  Here you will then click the Advanced Parameters.  In the Options section, you will need to add in 65536.

Codes

Once this is added and the config is validated and applied, calls are then passed through without issue.

(8764 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).