SEARCH
Knowledgebase: Network Access > Remote Access Server
What is the pin-out for the RJ45 to DB-9 converter?
Posted by Bob Puckett, Last modified by Danny Staub on 15 November 2017 04:07 PM

 To connect to the RS232 port you need a straight through cable and a RJ48C to DB-9 converter. These were included with your remote access server but if you have lost them, the pin-out for the converter is as follows: 
RJ45      DB9
  1    -    6  Data Set Ready
  2    -    1  Carrier Detect
  3    -    4 Data Terminal Ready
  4    -    5  Signal Ground
  5    -    2  Received Data
  6    -    3  Transmitted Data
  7    -    8  Clear to Send
  8    -    7  Request to Send
(8773 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).