The analog facsimile attached to a terminal adapter (which in turn is connected to a S0 interface of the SmartNode) does not send the called party number. Why?
Posted by Elena Brambilla, Last modified by Daniel Lizaola on 12 December 2017 05:15 PM
Analog faxes wait for a dial tone prior to send the called party number. Despite this the terminal adapter sends a setup message when hooking off the phone receiver (without called party number information element). If the routing tables of the SmartNode are configured such that any called party number is accepted no dial tone will be sent to the fax which means that the fax never sends the called party number dialled. Make sure that the routing tables are programmed such that a dial tone (continuous tone signal) is generated.
(8764 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).