Knowledgebase:
Configure Patton SmartNodes with 3CX v20
Posted by Danny Staub, Last modified by Danny Staub on 05 December 2024 11:31 AM


Configure Patton SmartNodes with 3CX v20

(FXO and PRI)

 

Step 1: Create a “VoIP Gateway trunk” on 3CX

  1. From the Admin panel, click on“Voice & Chat” and then on “Add Gateway”.
  2. Specify a name.
  3. Enter the gateway’s “Main Trunk Number”.
  4. In “Registrar/Server”enter the SmartNode’s IP address.
  5. Set the "Default Route".
  6. Take note of the Authentication ID and password

  

  1. Click on the “Options” tab and enter the “Number of sim calls per trunk” for this gateway. (This must not exceed the number of lines the gateway supports, e.g. a T1 gateway supports 23 lines.)
  2. Click “Save” and the gateway is now configured in 3CX.
  3. The last step is to create an Outbound Rule for this gateway. Once complete, click “Save”.

 

 

 

 

 

Step 2: Configure your SmartNode with 3CX

  1. Run the configuration WEB WIZARD for your SmartNode device and fill in the required information. 

 

  1. Trinity FXO WEB WIZARD
  • Fill in the following tabs of the web wizard

 

  • Device Management Tab
    • Here you can change the default admin password.

 

 

  • Network Settings Tab
    • Set the IP address as either DHCP client or a Static address.

 

  • FXO Port Settings Tab
    • Select the number of FXO ports (1-8)
    • Select the country tone-set profile (United States and Europe)

 

 

 

  • 3CX SIP Settings Tab
    • Server IP Address: Enter the IP/FQDN of 3CX
    • Set the Authentication ID and Password (This was previously configured in 3CX for this gateway)

 

 

 

  • Once everything is filled out, you can select “Save” and the config file will be downloaded.

 


 

  1. ISDN WEB WIZARD
  • Fill in the following tabs of the web wizard

 

  • Device Management Tab
    • Here you can change the default admin password.

  

 

  • Network Settings Tab
    • Set the IP address as either DHCP client or a Static address.

 

 

 


 

  • ISDN Port Settings Tab
    • Select the number of ISDN ports (1-4)
    • Select the PRI Line Type (E1 or T1)
    • Select what the ISDN port is connecting to (PBX or PSTN)
    • Select the country tone-set profile (United States and Europe)

 

 

 

  • 3CX SIP Settings Tab
    • Server IP Address: Enter the IP/FQDN of 3CX
    • Set the Authentication ID and Password (This was previously configured in 3CX for this gateway)

 

 

 

  • Once everything is filled out, you can select “Save” and the config file will be downloaded.

 

 

  • Load in Config File
    • Enter the IP Address of the SmartNode into a web browser
    • Login using the default username and password of admin/<no password>
    • Click the top left-hand menu and navigate to “System/Configuration Files” and click the “+” button
    • Browse to the file generate and import in as the “startup-config” and click OK
    • Reboot the unit without saving

 

 

The unit should boot up and register to 3CX to make a receive calls.

 

(13 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).