Knowledgebase: Unified Communications
Mapping-Tables in the SmartNode 1k Series
Posted by Danny Staub on 22 February 2018 03:52 PM
Patton SmartNodes have a very complex digit manipulation engine that is highly configurable for most parameters within a call setup. |
Creating/Entering and changing a Mapping-Table:
To do this, you must be in the 'context cs' section of the configuration.
(ctx-cs)# mapping-table <input-type> to <output-type> <name>
(map-tab)[MAP]#map <input-value> to <output-value>
mapping-table called-e164 to called-e164 REM_PREFIX_911
map .(.%) to \1
ex. If you have to dial a 9 to get an outside line
9911 converts to 911
(Helps comply with the newly enacted 'Keri's Law')
mapping-table calling-e164 to calling-e164 ADD_00
map (.%) to 00\1
ex. If you want to have a prefix added to every number dialed (For accounting purposes, least call routing, etc...)
3019751000 gets mapped to 003019751000
mapping-table called-e164 to calling-pi CNPN_PI
map *31*(.%) to restricted
ex. If you need to change the presentation for Privacy reasons
When *31*1234567 is dialed, the Presentation Indicator is mapped to restricted.
To use multiple mapping-tables, a Complex-Function can be configured. This is an ordered list so be aware of this when creating this complex-function.
execute 1 CNPN_PI
execute 2 REM_PREFIX
How to use a Mapping-Table:
Mapping-Tables are best used within a routing-table. See the example below that uses the mapping-table listed above (REM_PREFIX_911).
routing-table called-e164 OUTBOUND
route .T dest-interface IF_SIP REM_PREFIX_911