Knowledgebase: Unified Communications
Create Line Interface
Posted by Laszlo Varro, Last modified by Dan Smith on 25 July 2018 03:01 PM

Now you will need to create a new line interface for your ISDN-SIP Gateway system. Line interface is a generic term for TDM physical interfaces. SmartMedia supports 3 types of physical interfaces:

  • T1/E1/J1 interfaces
  • DS3 interfaces
  • SONET/SDH interfaces

To create a new line interface:


1- Select Tdm Interfaces-->Line Interfaces from the navigation panel

Toolpack v2.5 Navigation Panel Line Interfaces.png


2- Click Create New Line Interface to create a single interface ,or Create Multiple Line Interfaces to create many interfaces at once

Toolpack v2.5 Create Line Interface.png


3- Create the new line interface:

  • Enter a name for the interface
  • Set a type for the interface
  • Set a local index for the line
  • Select a length and an encoding scheme
  • Click Create

Toolpack v2.5 Creating Line Interface.png


4- Verify that the "Line interface was successfully created" message is displayed

Toolpack v2.5 Line Interface Created.png

(1445 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).