RSS Feed
Knowledgebase : Network Access > OnSite > RocketLink
Procedure: 1. Reboot router while holding the spacebar; make sure you are connected using the console port. (this will start unit in Boot OS) 2. Once you see the "]" prompt and see the cursor moving across the screen you can stop holding down the spac...
G.SHDSL is the newest standard for symmetric DSL. It works over 2-wires and improves both the distances achievable by DSL and the spectral compatibility with other services often present in a twisted pair bundle. The ITU standard for G.SHDSL is G.911....
In order to establish a G.HSDSL connection, there must be a modem on each end of the link. This does not mean that a DiamondLink/IAD modem must be on each end. The DiamondLink/IAD modem can be used with the following options on the other end of the twist...
Yes, both of these models support NAT (RFC3022) with Network Address Port Translation(NAPT). They also support MultiNat with 1:1, Many:1, Many:many mapping as well as Port/IP redirection and mapping.
Yes. They automatically learn, age and filter 1,024 source addresses. Destination addresses of incoming frames are compared with the Source Address in the address table and discarded if an entry exists; otherwise, they are forwarded over the DSL Extensio...
They are capable of connecting to Ethernet Hubs and Switches, remote PCs and any other network enabled device. The MDI-X switch is used to allow the units to connect to either a hub(DCE) or PC(DTE) device eliminating the neede to decide whether a stra...
The DiamondLink G.HSDSL routers supports all the SHDSL standards developed by ANSI (T1E1.4/2001-174, ETSI(TS 101524) and ITU-T(G.991.2). The routers offer selectable support for both Annex A (North America) and Annex B(Europe). They implement TC-PAM 16 a...
These models can easily be configured using several methods. The are user selectable to allow ATN, PPP or HDLC WAN data link connections and allow a variety of local and remote configuration and management options: 1. Web-based configuration via embed...
* Point-toPoint Protocol over HDLC * PPPoA(RFC2364) Point-to-Point Protocol over ATM * PPPoE(RFC 2516) Client for autonomous network connection. Eliminates the requirement of installing client software on a local PC and allows sharing of the conne...
Based on the ETSI and International Telecommunications Union (ITU) G.SHDSL G.991.2 standard, the Patton 3086 ipRocketLink enables nx64 (n=3..36 with software key to offer up to n = 72) over a single pair of wires and presents a unique dual port user inte...
They can be used in Internet applications(connection to ISP) or in the connection of remote branches using DSL access and IP/FR/ATM/PPP. Applications include: * Internet/Extranet Access * IP/FR and TDM Access (using TDM or FRF.5/FRF.8 internetwork...
Each 3086 comes with all of the following interfaces: * Control Port: An EIA-561 Rj-45 support external RS-232, VT-100 CLI configuration port * G.SHDSL Port: A two-contact shielded RJ-111F(RJ-45F available) * Ethernet Port: Eight contact shield...
1) Console or Telnet into the unit and login. 2) Click on "enable" and enter Supervisor password with is "root" by default. 3) Go to "setup". 4) Go to "bridge" 5) Enter the Gateway address here 6) Go back to the main screen and go to "write" 7...