SEARCH
Knowledgebase: Unified Communications > SmartNode > SmartWare
Why does the routes on my MS Windows machines change when a SmartNode is booted on the same subnet.
Posted by Elena Brambilla, Last modified by Daniel Lizaola on 12 December 2017 04:39 PM
The SmartNode is a router as per RFC1812/RFC1256 and thus sends "ICMP Router Discovery" messages to the subnet to which it is attached. Some MS Windows versions react to such messages and automatically adjust their routing tables. In order to avoid such unwanted routing table changes on MS Windows machines the "ICMP Router Discovery" can be switched off as follows (per interface):
 
context ip
  interface eth0
  no icmp router-discovery
 
(8748 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).