What must be observed with codec selection with H.323 FastConnect procedure in case of overlap dialing?
Posted by Elena Brambilla, Last modified by Daniel Lizaola on 12 December 2017 04:56 PM
|
|
When using H.323 FastConnect (which is usually the case) together with overlap dialing the voice codec is sometimes not known to the B-side SmartNode in the route lookup. The configuration fragment below exemplifies how to configure a SmartNode such that it also accepts such incoming calls:
context cs
The bold section shows an H.323 interface without codec. This interface is used by the B-side SmartNode in case overlap dialling is used on the A-side and FastConnect is enabled. | |
|
Comments (0)