|
Configuration Description
This example includes a basic configuration for the SmartNode SN5XXX to be used as a Session Border Controller in combination with two Cisco Call Manager (Primary and secondary). The configuration contains variables in brackets <>. Please Replace the variables including the brackets. Unused lines or variables have to be commented out or deleted
This configuration note gives an overview about configuring the SN5XXX with Cisco Unified Communications Manager (CUCM).
- SN5400 is used in this example.
Commande Sequence to copy, edit and paste
#----------------------------------------------------------------#
# Cisco Call Manager #
# #
# This example includes a basic configuration for the SmartNode #
# SN5XXX in combination with two Cisco Call Manager on the LAN #
# side and a SIP trunk to a VoIP provider on the WAN side. #
# This example can be used for other SmartNodes too. The only #
# thing which needs to be adjusted, are the ports and interfaces #
# as far as required. #
# #
# Author: Olivier Gaudet #
# Patton-Inalp Neworks #
# CH-3172 Niederwangen #
# www.patton.com; support@patton.com #
# #
# Date: 17/11/2011 #
# #
#----------------------------------------------------------------#
cli version 3.20
clock local default-offset +00:00
dns-client server <Primary_DNS_Server_If_you_use_hostnames>
dns-client server <Secondary_DNS_Server_If_you_use_hostnames>
webserver port 80 language en
sntp-client
sntp-client server primary 129.132.2.21 port 123 version 4
system
ic voice 0
profile napt NAPT_WAN
profile ppp default
profile tone-set default
profile voip default
codec 1 g711alaw64k rx-length 20 tx-length 20
codec 2 g711ulaw64k rx-length 20 tx-length 20
fax transmission 1 relay t38-udp
fax transmission 2 bypass g711alaw64k
fax redundancy low-speed 2 high-speed 1
fax bypass-method nse
modem transmission 1 bypass g711alaw64k
modem bypass-method nse
profile pstn default
profile sip default
no autonomous-transitioning
profile aaa default
method 1 local
method 2 none
context ip router
interface WAN
ipaddress <YOUR_IP_WAN_SIDE> <YOUR_NETWORK_MASK>
use profile napt NAPT_WAN
tcp adjust-mss rx mtu
tcp adjust-mss tx mtu
interface LAN
ipaddress <YOUR_IP_LAN_SIDE> <YOUR_NETWORK_MASK>
tcp adjust-mss rx mtu
tcp adjust-mss tx mtu
context ip router
route 0.0.0.0 0.0.0.0 <YOUR_DEFAULT_GATEWAY> 0
context cs switch
routing-table called-e164 RT_FROM_CISCO
route default dest-interface INTERFACE_TO_VOIP_PROVIDER
routing-table called-e164 ROUTE_FROM_PROVIDER
route default dest-service HUNT_In
interface sip INTERFACE_TO_VOIP_PROVIDER
bind context sip-gateway VOIP_PROVIDER_GW
route call dest-table ROUTE_FROM_PROVIDER
remote <YOUR_VOIP_PROVIDER_IP> 5060
interface sip IF_CISCO_CM
bind context sip-gateway CISCO_GW
route call dest-table RT_FROM_CISCO
remote <YOUR_PRIMARY_CALL_MANAGER_IP> 5060
interface sip IF_CISCO_CM2
bind context sip-gateway CISCO_GW
route call dest-table RT_FROM_CISCO
remote <YOUR_SECONDARY_CALL_MANAGER_IP> 5060
service hunt-group HUNT_In
timeout 3
allows-push-back
drop-cause normal-unspecified
drop-cause no-circuit-channel-available
drop-cause network-out-of-order
drop-cause temporary-failure
drop-cause switching-equipment-congestion
drop-cause access-info-discarded
drop-cause circuit-channel-not-available
drop-cause resources-unavailable
drop-cause recovery-on-timer-expiry
drop-cause no-route-to-destination
drop-cause no-route-to-network
drop-cause call-rejected
drop-cause protocol-error
route call 1 dest-interface IF_CISCO_CM
route call 2 dest-interface IF_CISCO_CM2
context cs switch
no shutdown
authentication-service AUTH_VOIP_PROVIDER
username <Username_SIP> password <Password_SIP>
location-service LOCATION_PROVIDER
domain 1 <YOUR_VOIP_PROVIDER_IP>
identity-group default
authentication outbound
authenticate 1 authentication-service AUTH_VOIP_PROVIDER username <Username_SIP>
registration outbound
register auto
context sip-gateway VOIP_PROVIDER_GW
interface IF_sip_interface_voip_provider
bind interface WAN context router port 5060
context sip-gateway VOIP_PROVIDER_GW
bind location-service LOCATION_PROVIDER
no shutdown
context sip-gateway CISCO_GW
interface IF_sip_interface_Cicso
bind interface LAN context router port 5060
context sip-gateway CISCO_GW
no shutdown
port ethernet 0 0
medium auto
encapsulation ip
bind interface WAN router
no shutdown
port ethernet 0 1
medium auto
encapsulation ip
bind interface LAN router
no shutdown
| 
(8748 vote(s))
Helpful
Not helpful