RSS Feed
Knowledgebase : Network Access > OnSite > DiamondLink
The model 3201 and model 3241 DiamondLink routers offer high-speed standards-based for long reach network extension. The model 3201 provides rates up to 2.3 Mbps and the model 3241 offers rates up to 4.6 Mbps. Connect them back-to-back or use them with on...
Procedure: 1. Reboot router while holding the spacebar; make sure you are connected using the console port. (this will start unit in Boot OS) 2. Once you see the "]" prompt and see the cursor moving across the screen you can stop holding down the spac...
G.SHDSL is the newest standard for symmetric DSL. It works over 2-wires and improves both the distances achievable by DSL and the spectral compatibility with other services often present in a twisted pair bundle. The ITU standard for G.SHDSL is G.911....
In order to establish a G.HSDSL connection, there must be a modem on each end of the link. This does not mean that a DiamondLink/IAD modem must be on each end. The DiamondLink/IAD modem can be used with the following options on the other end of the twist...
Yes, both of these models support NAT (RFC3022) with Network Address Port Translation(NAPT). They also support MultiNat with 1:1, Many:1, Many:many mapping as well as Port/IP redirection and mapping.
Yes. They automatically learn, age and filter 1,024 source addresses. Destination addresses of incoming frames are compared with the Source Address in the address table and discarded if an entry exists; otherwise, they are forwarded over the DSL Extensio...
They are capable of connecting to Ethernet Hubs and Switches, remote PCs and any other network enabled device. The MDI-X switch is used to allow the units to connect to either a hub(DCE) or PC(DTE) device eliminating the neede to decide whether a stra...
Some typical applications are: 1. Enterprise/Campus users deploying point-to-point network extensions 2. PTTs who want to offer standards-based DSL service using 3201 or 3241 as CPE to DSLAMs. 3. ILECs/CLECs connecting service to secondary metropolitan ...
The DiamondLink G.HSDSL routers supports all the SHDSL standards developed by ANSI (T1E1.4/2001-174, ETSI(TS 101524) and ITU-T(G.991.2). The routers offer selectable support for both Annex A (North America) and Annex B(Europe). They implement TC-PAM 16 a...
Yes, the DiamondLink routers are protected in compliance with all FCC Part 68 and UL1950 specifications. In addition, the DiamondLink routers are designed to meet ITU-T recommendation K12.
These models can easily be configured using several methods. The are user selectable to allow ATN, PPP or HDLC WAN data link connections and allow a variety of local and remote configuration and management options: 1. Web-based configuration via embed...
* Point-toPoint Protocol over HDLC * PPPoA(RFC2364) Point-to-Point Protocol over ATM * PPPoE(RFC 2516) Client for autonomous network connection. Eliminates the requirement of installing client software on a local PC and allows sharing of the conne...