How do I debug QoS? - Powered by Kayako Help Desk Software

Knowledgebase

(426)Unified Communications (65)Network Access (27)Connectivity (3)Provisioning (5)Patton Cloud

How do I debug QoS? Posted by Elena Brambilla, Last modified by Daniel Lizaola on 12 December 2017 05:06 PM
Debugging QoS is different from any other debug commands. It is a two step process. You must be in configuration mode. 1) Go into your service policy and specify "debug queue statistics detail 7" 2) Then do a show command: "show service-policy interface eth0". You can repeat this command as often as you want to view the current statistics.
(8748 vote(s)) Helpful Not helpful

Comments (0)

Post a new comment Reply to comment
Post a new comment Reply to comment

CAPTCHA Verification
CAPTCHA Verification

Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).