How can I do Call Transfer and FLASH codes on the SmartNode?
Posted by Elena Brambilla, Last modified by Daniel Lizaola on 12 December 2017 05:11 PM
|
|
SmartWare FLASH Codes -FLASH 0 - keep current, reject incoming -FLASH 1 - drop current, accept incoming -FLASH 2 - hold current, accept incoming To toggle between the active and the held call, press flash-hook, followed by the "2" key. Additional Call Offering To enable aditional call offering, configure the fxs port of the SN with the command: additional-call-offering 1) Press FLASH, then the first call is placed on hold and you will hear a new dial tone. 2) Dial the number of the second call. 3) If you press FLASH, you may change between the two calls. 4) When you hang-up on the phone, the two other parties are connected together. Sorry, three way conferencing is not yet supported. | |
|
Comments (0)