SEARCH
Knowledgebase: Unified Communications > SmartNode > SmartWare
Why does the Siemens Hipath PBX not show the Caller-Name with Qsig as signaling protocol
Posted by Elena Brambilla, Last modified by Daniel Lizaola on 14 December 2017 05:37 PM

The only Siemens Qsig Protocol, which is interoperable with the SmartNode products is ISO-QSIG.

You must choose as QSIG version ISO-QSIG.

All other Siemens Qsig versions show restrictions in the supported supplementary services, such as the caller name.

 

On all ISDN SmartNodes SN4xxx, the following QSIG standard is supported.


"ECMA-143" ISO/IEC 11572, ETSI EN 300 172

(8748 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).